Embossing machine

The embossing machine is a small equipment, which adopts vacuum tube, the input power is the same, the industrial belt oscillation frequency is 2712mhz, and the input duty cycle is unchanged, which meets the standard. The pressure of the strong indenter can be adjusted at any time. The manipulation of the lever stimulates the reality, so that the average pressure, up and down bumps, and the severity of the indenter of the embosser can be adjusted at will. The common welding needs of different scales, plus the rainwater collection with double springs, riding a special lamp and P pressure scale, this product can be connected with good results, especially suitable for products that are difficult to align

the embossing machine prevents interference with radio installation, and has high-frequency and high-frequency constant frequency barrier installation, with small high-frequency interference; When the installation task current load exceeds the excellent value during refuge, the overload current relay will actively intercept the pressure and shelter the oscillation tube and r. Characteristic words. While preventing improper operation caused by frequency drift, electrode and material protection, while minimizing the warning light, the technical embossing machine is adopted to improve the efficiency of the warning light

the embossing machine eliminates the cumbersome and stable shelter installation operation. Inevitably, the embossing machine will bring earth shaking changes, and the embossing machine will occupy a cooperative position in the pilot production

check the hydraulic oil before using the embossing machine. When the hydraulic oil height is 2/3 of the base height, when the refueling time is insufficient, fine filtration should be carried out before fuel injection. It adds pure hydraulic oil to the next refueling hole 20. It is generally suitable for stations with two-thirds of the height lower according to the oil level benchmark

check the lubrication between the guide pillar shafts and add oil in time to maintain good lubrication

power, move the joystick to the vertical position to close the oil return port, press the button to start the motor, the oil enters the cylinder from the pump, and the piston drive rises. When the hot plate is closed, the pump continues to supply, and when the stop button is pressed, the oil pressure rises to the required value (14.5mpa). When the machine is in the state of stopping packaging (i.e. timing vulcanization), reach the curing time, move the plunger to lower the handle of the mold

hot plate temperature control: rotate the close button SA1 to start the heating plate. When the temperature reaches the preset value, the heating will automatically stop. When the temperature is lower than the set value, the tablet is automatically heated, and the temperature is always maintained at the set value

vulcanizer control operation: press the button to start the motor, etc. 2. The AC contactor is powered on, and the pump runs. When the hydraulic pressure reaches the set value, the AC contactor is disconnected, and the starting curing time is automatically recorded. When the pressure drops, the pump motor starts automatic charging, reaching s. When et solidifies, Xiang Qi beeps to inform that the solidification time is up. You can turn on the mode, press the buzzer stop button, move the manual valve, and the board drops, which may be the next cycle