Leveling machine

The leveling machine has the characteristics of convenient and simple operation, and it can complete leveling / pressing / punching / corner cutting at one time according to the requirements. The finalization of the leveling machine mainly depends on the requirements of the thickness, material and width of the steel strip coil to be calibrated. The thicker the material, the better the structural rigidity required, the fewer the number of rollers, the larger the roller diameter, and the greater the power (the width is determined)

leveler is a commonly used equipment in steel plate processing. It is mainly used to correct steel plates of various specifications and steel plates cut into blocks. It is widely used in many industries such as machinery, metallurgy, building materials, chemical industry, electronics, electric power, light industry, especially in shipbuilding, locomotive and rolling stock, boiler and bridge, metal structure factory and other industries. It has become an excellent contract abiding product in production

operating instructions of leveling machine:

1. When starting up, select the forward and reverse rotation first after the emergency stop is turned on. In operation, do not select the forward and reverse rotation, but shut down first

2. When starting up, turn on the fan first, and then start the host. When stopping the machine, first press the main machine to stop, and then turn off the fan. If the sequence is wrong, it may damage the electrical appliances

maintenance of leveling machine:

after the leveling machine is debugged and can be used, users should understand the maintenance of the machine. There are mainly the following aspects:

1. Where there are grease fittings, add them once a month. Mainly the lubrication of bearings

2. Pay attention to the cleanness of the roll surface. No welding slag, short sheet metal or other things are allowed to fall into the roll room to avoid damaging the leveling roll

3. After long-term use, check whether any screws and nuts are loose and tighten them with a wrench

technical parameters of leveling machine equipment:

number of leveling passes: up 6 down 7

diameter of leveling shaft: 125mm, thickness of medium plate: 30mm

host power: 7.5kW, power of hydraulic station: 7.5kW

transmission mode: wallboard gear transmission

shearing mode: full automatic numerical control counting, with frequency conversion, accurate counting

number of leveling passes: up 6, down 7

500mm wide, 3mm thick leveling automatic cutting equipment parameters:

transmission mode: wallboard gear transmission

host power: 5.5kW, hydraulic station power: 5.5kw

leveling shaft diameter: 125mm, medium plate thickness: 25mm

cutting mode: automatic numerical control counting, with frequency conversion, accurate counting