840-900-850 water ripple three-layer tile press manufacturer

The 840-900-850 water ripple three-layer tile press can also be called roller cold bending forming, which is a plastic processing method of connecting metal plates and metal strips on a series of forming mills, sequentially bending them, and processing the flat plate into the desired cross-sectional shape. Roller cold bending forming (840-900-850 water ripple three-layer tile press) was once used in the manufacturing of bicycle wheels, umbrella frames, and so on.

Debugging of 840-900-850 water ripple three-layer laminating tile machine

1. First, align the height of the four corners of the front and rear rows of the 840-900-850 water ripple three-layer tile press machine from the main frame to the upper end of the bottom shaft. Then, from the first row to the last row, find a straight line and check if the lower shaft is in a straight line. Adjust the left and right sides of the lower shaft to be horizontal.

2. Find the center of the first and last rows of the 840-900-850 water ripple three-layer tile press, then tighten the locking nuts on both sides, and draw a straight line in front and behind the center of the middle wheel. After adjusting the gap between the upper and lower shafts, the machine can be adjusted in a straight line.

3. The debugging method for the pressure plate deviation of the 840-900-850 water ripple three-layer tile press, such as running the plate to the right, padding the left corner (feeding frame), or falling to the right bottom flat (which axis deviates and falls to the bottom flat of which axis, and the upper axis falls with the bottom axis).

Electricity precautions for 840-900-850 water ripple three-layer tile press

1、 Electricians should understand the wiring in the workshop and the type and performance of equipment. Those who do not have a clear understanding of the performance of their equipment cannot take risks in using it.

2、 Electricians need to set a time to check the condition of the motor and electrical control panel. During the inspection, they should see the situation and take appropriate measures. When checking the degree of the motor, first check that there is no electricity, and then check according to the back of your hand.

3、 In addition to temporary electrical measures for construction work, it is not allowed to install temporary wires, hang lights randomly, use stable sockets for tools, welding equipment, etc. The previous wires cannot be changed arbitrarily.

4、 According to regulations, his products should be inspected and cared for on schedule, and any unused electrical product wiring should be dismantled.