Feeding rack

There are several kinds of feeding racks. One is the ordinary type. There are four screws at both ends, which are directly tightened with a wrench. There are great skills here. Many customers and friends did not pay attention to it. When winding the top screws again, use a steel ruler to measure the axis to the center of the roll, and adjust the height of the four screws as much as possible. In this way, the good color rolls can rotate flexibly, and there will be no phenomenon that half a turn and the other half a turn can't be rotated by two people. The support should be placed on a solid ground, and the ground plane should be very flat to prevent the phenomenon of leaning to one side during use, so as to avoid hurting the operator. When selecting the material rack, the key is to pay attention to whether the welded junction is full and the material is strong enough. Especially the column part should be welded on the plane of the frame, so that the vertical downward force can be fully transmitted to the ground and improve the stability of the material rack

the discharging rack has large bearing capacity and long service life

the discharging rack is characterized by brake and core expansion

the feeding rack includes a base, the two ends of the base are respectively installed with screw rods, the screw rods on one side are connected with pulleys, the screw rods on both sides are respectively sleeved with connecting collars, the collars are respectively connected with the supports, the supports are respectively inlaid on the surface of the base through the side plates on both sides, and the supports are respectively connected with the conical frame through the rotating shaft